Purchashed a 224ce k deluxe($2000)
Purchashed a 224ce k deluxe($2000). Solid koa top 3 layer laminate on the sides and back. Outter layer koa, other 2 ,??. The "kerfing" on the interior does not fully wrap up to the butt stock leaving top and sideglue joints in these areas unsupported....? Believe the glue in these areas is enough to keep the lid on?The case, two of the clasps had their guide tabs totally bent over making it difficult to line up and latch. I corrected this qa failure. The side outside laminate of koa in the cut out area shows signs of separation covered by the finish. Will this delamination continue,I guess I will see. Taylor says their 100&200 series have shown this condition. So, I have a 94 814c, 97 555 both American made. In conclusion it is obvious that the quality standards used by taylor guitars in America are not followed in Mexico, no matter the hype. For 2000 dollars, it's quality of construction is less than comparable to the 350 dollar sigma setting next to it. Hope that Koa top was worth it. Final thought don't let the name on the headstock influence your decision. We are living in the age of affordable quality instruments. Sincerely, floyd Lake
By Johnny D.