AmeriGlide Distributing 2019, IncReviews of ameriglide.com

Timothy was very helpful and walked me through the entire process. I hope he is able to expediate my order so we can have the system installed in time for my Dad's discharge from the rehab hospital on January 24th.

The VivaLift Power Recliner by Pride Mobility Products Inc. I purchased for my elderly Mother exceeds all expectations! I’ll be recommending this product and Ameriglide to friends looking for this and similar products.

My wife and her siblings were researching a lift chair for her 91 yr old mother, who still lives at home independently. I came across the AmeriGlide website and setup a Saturday appointment to have my mother-in-law look at the variety of lift chairs in their showroom. The sales associate, Austin, was attentive and informative, as he was questioned about each chair and its pros and cons. We purchased on the visit and the lift/recliner chair was delivered to my mother-in-law's home on the following Tuesday, as promised. Most appreciative for Austin and his assistance, as is my wife, her siblings, and my mother-in-law.

You are not finished yet. Check me later, after the installation.

My salesperson was the best!! Knowledgeable, quick with responses to all my questions and very easy to talk with. The package arrived as expected and delivery was great.

Great salesperson: Timothy from Tempe, AZ. Was able to explain to me the differences in stairlifts and offer $100 off and give me detailed descriptions of what was needed for measurements. Asked great questions and even saved on sales tax! Wonderful process and company! Affordable pricing for their new stairlifts!

The install of the Ameriglide Rave2 stairlift went smoothly. I enjoyed putting it together. One weak point in the instructions i will mention is step 2 of "chassis installation". I found the one photo, Figure 4-15, difficult to interpret. It looked like there was a curved plastic cup of some sort under the chassis just above the top of the landing. It wasn't until I looked at the photo upside down that the curved edge of the "cup" was actually a wire lead. I would reshoot this photo for the instruction brochure. Also, because the chassis is quite heavy and has no really good hand-holds which don't put the installer's fingers in jeopardy when sliding it onto the rail, I devised an easier and safer method. I measured how high the lower edge of the upper end of the rail was above the upper landing, in my case 8 inches. I then stacked large books 8 inches high on the landing at the end of the rail. I set the chassis onto the books and maneuvered it so that the bottom edge of the railing was positioned just opposite the opening in the chassis into which the rail inserts, then simply slid the chassis onto the railing, supporting the back end of the chassis in the process. With this method, other than when placing the chassis onto the book stack it isn't necessary to support the entire weight of the chassis during installation onto the rail. One other suggestion. Under "FINAL RAIL INSTALLATION", Step 5 (installing the end plate), the plate is installed using 4 self-cutting Torx screws. Even using grease on the screws I did not have enough strength to screw those suckers all the way in. I wound up getting an appropriate size tap and cutting threads most of the way into the holes before attaching the end plate with the screws. This was far easier, and the screws are plenty tight. I would suggest these holes be tapped at the factory. All in all, I found this stairlift to be an amazingly well engineered product with parts that fit amazingly well. It was a pleasure to install.

I have purchased Ameriglide product in past and am most satisfied. This stairlift purchase makes me feel I am dealing with reputable and quality, reasonable American made product. Pricing is reasonable for the Rave 2 Kelly, (cust. service rep) pleasant , helpful and most informative