Haas AutomationReviews of haascnc.com

We had just purchased a brand new UMC 750 with the 10 +1 pallet pool system arrived beginning of July. it took them all month to put it together with three different tech guys coming out to work on it. After they were done I started to work on it and found the following problems. 1. Can not peck drill more than 25 pecks. does not matter what drill cycle you use G83 or G73. 2. With the DWO on, the machine reads to turn off cutter comp and slows down to a snails pace then goes back up to original feed rate it was programmed for after it finishes the comped move. 3. Newer software does not work as well as the older software. had to down rev the newer software in order to get programs to work sufficiently. 4. Pallet pool switches quit working after two full days of use.

Horrible, horrible CNC lathe control. Stay as far away as you can from any machine after 2017 with the "NGC" (next gen. control). Features some of the most annoying safety controls that any qualified setup personnel doesn't need to or want to deal with. Who needs to close the door for every turret index, or be limited to 500 RPM with the door open, or have MDI that really isn't MDI?? Haas fails to realize the needs of truly qualified CNC setup personnel and completely misses the mark with their "NGC"!! If you enjoy annoying little things like that, then maybe this is ok for you. For a few bucks more, get yourself a Doosan with Fanuc, you'll thank me later.